|Type||Mid Tower Case|
|I/O Port||USB3.0X1+USB2.0x2 +HD-AUDIO+MIC|
|Fan Support||120mm * 2 /80mm * 1|
|Pre- Installed Fans||Front:120mm RGB Fan * 2 (Included)|
|PSU||Bottom Loaded,0.5mm Steel|
|Side Panel||Left: Tempered Glass|
REVENGER GHOST Mid Tower ATX Gaming Case comes with the support for up to a 240mm liquid cooling radiator in front, GHOST is easy to build. The GHOST gaming Case comes with USB 3.0 connectivity, ample storage drive bays, and room for expansion.
Motherboard Compatibility and I/O Ports:
This REVENGER GHOST Mid Tower ATX Gaming Case supports ATX, Micro-ATX, and ITX motherboards, and is featured with Mid Tower Form Factor, Power, LED Control Button (Just a single press to change the front panel’s ARGB lighting effect at will), USB3.0X1+USB2.0x2 +HD-AUDIO (On Top) Front Access & Controls, Tempered Glass Side Panel.
Supports up to 6 fans
Here, 3 x 120mm ARGB fans in front are Included fans and also support a 1X12cm ARGB Fan on Back Side, 2x12cm ARGB Fan in Top panel, and 1x3 ARGB Rear Fan in the Rear. This gaming Case has Dust Filter on the Top/ Bottom.
LED Control Button
- Mid Tower Case in Black Chassis
- Dimensions: 330x185x412mm
- PSU bottom-loaded, 0.5mm Steel
- USB3.0X1+USB2.0x2 +HD-AUDIO (On Top)
- Acrylic Glass side panel
- 2 RGB Front Fan Pre-Installed
- Flaming RGB Lighting Scheme Strip
- 3.5" HDD*2 + 2.5" SSD*1
The Revenger Ghost Case is pretty well constructed and very easy to build in. It has ample cable management room and feels solid overall. I like the overall size as it not massive while fitting an ATX motherboard without any major problem. If you are going to install a graphics card, then please measure first before buying as it won’t have as much room as a large case.
The Revenger Ghost RGB lights on the fans can be turned off by holding the LED button if those bother you. Otherwise, you can press it to rotate between different color presets. The fans are all powered by a single SATA power connector instead of the motherboard fan headers which may confuse some builders during assembly.
The default Revenger Ghost Case fans are a little nosier than what I use on my personal builds; however, they are not too loud or give off any annoying hums or rattles. I believe most people would be very pleased with the noise levels. You may wish to add a rear Case fan to further improve airflow performance. The fans included were all installed in the front of the Case.
It’s hard to beat this value for the price if you are doing a lower-budget build.